Monitoring Wear Debris In Hazardous Environments
Kittiwake’s ATEX Metallic Wear Debris Sensor facilitates real-time wear debris monitoring for both ferrous and non-ferrous metals in hazardous areas. Capable of being mounted within any lubrication system, on any type of asset, it uses a combination of inductive-coil technology and algorithms to provide a particle- size distribution count. ATEX and IECEx certifications allow the product to be used in environments where explosive gases are likely to be present.
For more info, enter 30 at www.LMTfreeinfo.com
Easy, Less-Messy Oil-Sampling
According to JLM Systems, the Pass-Thru technology on its recently introduced OILMISER™ Pass-Thru Sampling Valve (SV-PT) is a game changer for oil sampling. Designed with a plated steel body and Hex cap with chain tether, the device’s Pass-Thru feature allows a ¼” OD plastic tube or the OILMISER™ pass-through pitot tube to be inserted from the outside into the machine from which oil is being sampled. A tube seal/wiper strips surface oil from the sampling tube. The new SV-PT is available with a ¼”, 3/8”, ½” or ¾” NPT male pipe thread.
JLM Systems Ltd.
Richmond, BC, Canada
For more info, enter 31 at www.LMTfreeinfo.com
Severe-Service Rotary Shaft Seals
Kalsi Enginering’s 568-Series Enhanced Lubrication rotary shaft seals were developed to reduce torque and seal-generated heat in the type of high-pressure surface applications where higher hydrodynamic leakage can be tolerated and thinner viscosity lubricants may be encountered. Dual Durometer configurations are available to augment high-pressure extrusion resistance. These seals are suited to oilfield surface applications like rotary blowout preventers, rotary heads and multi-port hydraulic swivels.
Kalsi Engineering, Inc.
Sugar Land, TX
For more info, enter 32 at www.LMTfreeinfo.com
Cleanliness Indicators For Hydraulic Filters
Schroeder Industries’ MS Electrical Dirt Alarm® Indicator Series is suited for use with a range of the company’s hydraulic filters. The products alert users of the need to change out an element, thus helping maintain crucial fluid cleanliness. A crimped body design eliminates the need for the four bolts used in the product’s existing design, reducing cost and assembly time. A thermal lockout option can help prevent false indications during cold starts.
For more info, enter 33 at www.LMTfreeinfo.com
Quick-Working Leak Sealant
StopIt HP™ from InduMar Products is a leak sealant for working pressures up to 2000 psi. To apply, users mix a premeasured, two-part sealant, wet a fibrous reinforcement tape and wrap it around the pipe surface. The sealant can be applied regardless of pipe orientation, and provides a durable coating approximately 5 mm thick. It has a working time of 8-10 minutes and requires as little as four hours to cure.
InduMar Products, Inc.
For more info, enter 34 at www.LMTfreeinfo.com